Ip address to mac converter3/10/2024 ![]() Of the 48 bits used to represent the multicast MAC address, the high-order 25 bits are reserved as part of the OUI, and the last 23 bits of the multicast IP address are used as the low-order bits, as shown in Figure 2-4.įigure 2-4 Layer 2 Multicast Address FormatĪ switch can use this calculated multicast MAC address to distinguish a frame as a multicast and make efficient forwarding decisions. The high-order 4 bits for the destination IP multicast address are set to 1110 binary (0b1110). The lower-order 23 bits of the destination IP multicast address are mapped to the lower-order 23 bits of the MAC address. These bits are part of the organizational unit identifiers (OUI). The high-order 25 bits is the official reserved multicast MAC address range from 0100.5E00.0000 to (request for Comment 1112). The sending device must convert the destination IP multicast address into a special MAC address as follows: What happens when it is a multicast message? To optimize network resources, an Ethernet switch also needs to understand multicast. ![]() ![]() As discussed in Chapter 1, when a device sends a broadcast frame, the destination address is all ones, and a unicast message is the destination MAC address. A traditional Ethernet switch (Layer 2 device) works with Ethernet frames, and a traditional router (Layer 3 device) looks at packets to make decisions on how messages will be handled.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |